The Autonerdz Community Forums - amp clamp configuration

	Welcome, Guest. Please Login or Register

Home

Help

Member Map

Event Calendar

The Autonerdz Community Forums › General Public Area › PicoScope › amp clamp configuration

‹ Previous Topic | Next Topic ›

Pages: 1 2

Send Topic

amp clamp configuration (Read 711 times)

Tom Roberts

Autonerdz Administrator
Picogroup

Offline

Autonerdz Founder

Posts: 8,598

Olympia
Washington
USA
Gender: male

Re: amp clamp configuration
Reply #15 - Feb 16^th, 2015 at 1:27pm

Blue_Heisenberg wrote on Feb 16^th, 2015 at 12:52pm:

Can I become a picogroup member without subscribing to the whole auto nerdz membership

Sorry, no. The extensive resources that are included in the Picogroup subscription, are integrated together and there is no practical way to separate out any one component. They are all interdependent and a part of the total Autonerdz PicoScope experience.

Tom Roberts
Forums Administrator

IP Logged

Blue_Heisenberg Freshman Member Offline I'm an Autonerd Posts: 35	Re: amp clamp configuration Reply #16 - Feb 27^th, 2015 at 10:09am Could you suggest any settings for this probe http://www.aeswave.com/Current-Probe-High-range-Generic-brand-p8480.html Using the preset 600amp function doesn't show a very good signal. Thanks
Back to top	IP Logged

Tom Roberts Autonerdz Administrator Picogroup Offline Autonerdz Founder Posts: 8,598 Olympia Washington USA Gender:	Re: amp clamp configuration Reply #17 - Feb 27^th, 2015 at 10:24am Blue_Heisenberg wrote on Feb 27^th, 2015 at 10:09am: Using the preset 600amp function doesn't show a very good signal The amps/volts ratio is the same. What's not good?
Back to top	Tom Roberts Forums Administrator IP Logged

Blue_Heisenberg Freshman Member Offline I'm an Autonerd Posts: 35	Re: amp clamp configuration Reply #18 - Feb 27^th, 2015 at 11:26am Well when I was trying to do a compression check the signal looked nothing like it should. What time Base and amp division would you recommend on the 600 amp preset?
Back to top	IP Logged

Tom Roberts Autonerdz Administrator Picogroup Offline Autonerdz Founder Posts: 8,598 Olympia Washington USA Gender:	Re: amp clamp configuration Reply #19 - Feb 27^th, 2015 at 12:02pm Post up what you have and maybe I can comment. But...see reply #13. Again, the real PicoScope help is in the Picogroup areas.
Back to top	Tom Roberts Forums Administrator IP Logged

Pages: 1 2

Send Topic

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page

Autonerdz forums