The Autonerdz Community Forums - Pico TA041 Differential Probe

	Welcome, Guest. Please Login or Register

Home

Help

Member Map

Event Calendar

The Autonerdz Community Forums › General Public Area › PicoScope › Pico TA041 Differential Probe

‹ Previous Topic | Next Topic ›

Pages: 1

Send Topic

Pico TA041 Differential Probe (Read 167 times)

LRT Freshman Member Picogroup Offline I'm an Autonerd Posts: 1 Garvoc, Victoria Victoria Australia	Pico TA041 Differential Probe Jan 14^th, 2015 at 2:19am I have recently purchased a Pico TA041 Differential Probe. However, when I connect to a 240 Volt AC portable engine driven power supply, I can only capture the Hz sine wave and not the voltage produced by the power supply. Also, the sine wave does not fit in the viewing window, even when set at x1 zoom. What am I doing wrong? LRT
Back to top	IP Logged

Tom Roberts

Autonerdz Administrator
Picogroup

Offline

Autonerdz Founder

Posts: 8,598

Olympia
Washington
USA
Gender: male

Re: Pico TA041 Differential Probe
Reply #1 - Jan 14^th, 2015 at 8:34am

LRT,

PicoScope help is provided in the Picogroup boards. You are a member, so post there for better assistance.

LRT wrote on Jan 14^th, 2015 at 2:19am:

I can only capture the Hz sine wave and not the voltage produced by the power supply.

You'll have to deploy a measurement like AC RMS. Make sure your scaling is correct and use an appropriate software probe that matches your TA041 range selection.

Tom Roberts
Forums Administrator

IP Logged

Pages: 1

Send Topic

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page

Autonerdz forums