I'd like to ask what method do you all use for verifying grounds?

The Boss demands all grounds be voltage drop tested using a DVOM, not a scope. I understand that grounds always look hairy and noisy but with some simple filtering that can be eliminated. Is there a setting that numbs a scope to act just like a DVOM?

TrevorSchlientz wrote on Jun 15^th, 2016 at 9:29am:

I'd like to ask what method do you all use for verifying grounds? The Boss demands all grounds be voltage drop tested using a DVOM, not a scope. I understand that grounds always look hairy and noisy but with some simple filtering that can be eliminated. Is there a setting that numbs a scope to act just like a DVOM?

It depends...

I do it both ways.

TrevorSchlientz wrote on Jun 15^th, 2016 at 9:29am:

Is there a setting that numbs a scope to act just like a DVOM?

You can use the measurement option and enlarge the #s

---

Mick wrote on Jun 15^th, 2016 at 6:44pm:

Spence wrote on Jun 15th, 2016 at 10:31am: Is there a setting that numbs a scope to act just like a DVOM? You can use the measurement option and enlarge the #s

Hi Mick! I don't think I wrote what you quoted above.

Have a good day

Spence

That is a technique I will need to start practicing.

Thank you Mick  [smiley=notworthy.gif]

Spence wrote on Jun 16^th, 2016 at 4:46am:

Hi Mick! I don't think I wrote what you quoted above.

edited  :D


Spence wrote on Jun 16^th, 2016 at 4:46am:

Have a good day

Back at ya ;)