The Autonerdz Community Forums

The Autonerdz Community Forums
https://yabb.autonerdz.com/cgi/yabb2//YaBB.pl General Public Area >> Test Board >> SEANMAC, what's the deal with this? https://yabb.autonerdz.com/cgi/yabb2//YaBB.pl?num=1333512843 Message started by PRESTON on Apr 3^rd, 2012 at 8:14pm

Title: SEANMAC, what's the deal with this?
Post by PRESTON on Apr 3^rd, 2012 at 8:14pm

Hey man, I was just looking over your waveforms, still don't see much of anything. You have the engine listed as a 4 cylinder, but if I mark off 1 complete engine cycle ( or 2 crank revolutions ), the RPM seems to be way too high for cranking. More capture time on the screen would be helpful when trying to diagnose with waveform type captures.

SEANMAC_FLS_TEST.jpg (120 KB | )

Title: Re: SEANMAC, what's the deal with this?
Post by SEANMAC on Apr 4^th, 2012 at 7:05am

Engine idleing hot dis ignition system.

Title: Re: SEANMAC, what's the deal with this?
Post by PRESTON on Apr 4^th, 2012 at 7:31am

Okay, that makes much more sense. Still don't see anything wrong, was it actually missing at the time of this capture? From the looks of it I would say no.

Title: Re: SEANMAC, what's the deal with this?
Post by SEANMAC on Apr 4^th, 2012 at 8:52am

No running normal at that time.when i get it back i will do some captures with more time on the scope thanks for the responce.

Title: Re: SEANMAC, what's the deal with this?
Post by PRESTON on Apr 4^th, 2012 at 8:55am

no problem chief

Title: Re: SEANMAC, what's the deal with this?
Post by fisher on Apr 4^th, 2012 at 2:29pm

Response - with an s - is the correct spelling, Seanmac.