The Autonerdz Community Forums
https://yabb.autonerdz.com/cgi/yabb2//YaBB.pl
General Public Area >> PicoScope >> 2000 Pontiac Bonneville P0102
https://yabb.autonerdz.com/cgi/yabb2//YaBB.pl?num=1188854351

Message started by Rafael on Sep 3rd, 2007 at 1:19pm

Title: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 1:19pm
Hello Nerdz,

Its a pleasure to be back and see that you all been busy.

This car is very well take care of is experiencing some jerking and lack of power simptoms - intermittently.

Costumer stated that the car started acting up after  an alignment job. He suspects that someone did something to his car and messed it up.

CEL is off, however there are two History Codes Recorded - P0120 and P0420.

I have to mention that the catalyc converter has been removed from vehicle.
pontiac.gif (166 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 1:37pm
I drove the vehicle with costumer, the car ran good the whole time while he was there. Later on I took the car to pick up some parts and the car started jerking and loosing power and then quit.

Once I got to the shop the car was idling rough so we started gathering data this what we found.
maf_fequency.gif (56 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 1:45pm
Until mass air flow sensor frequency drops way below specifications.
maf_frequency2.gif (63 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 1:48pm
And the frequency just droped to the ground.

What are we going to do next?
bad_mas_air_flow.gif (53 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 1:57pm
Remember this codes can be the result of the following:

* Vaccum Leak/Faulty PCV
* Maf sensor element contaminated
* Sensor signal shorted to ground
* CKT /Harness problem
* Faulty ECM


underhood.gif (301 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rich Barton on Sep 3rd, 2007 at 3:07pm
Hi Rafael:

Did you do the tap test on the maf with a screwdriver like this ;)
tapping_on_maf.gif (102 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Mick on Sep 3rd, 2007 at 3:51pm
Hi Rafael

A tap test is in order But a wiggle test will show a loose connection inside the maf not to be confused with terminal tension as I found out once

Now that Rich has to many tools  [smiley=devious.gif]but the best must have been used on another car that day  [smiley=undecided.gif]he should have used this one  [smiley=rolleyes.gif] tap test at idle

Mick
for_rafael.gif (70 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 3:57pm
Yes Sir,

Here is a tap test.

But first look at this Failure Data/freeze frame data.

Man you're good.
failure_data.gif (68 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rich Barton on Sep 3rd, 2007 at 4:08pm
Mick you beat me again [smiley=rockon.gif]  I guess I should of told him about the tension test, my wife was telling me it was time for my [smiley=bath.gif] so I had to make it quick

My Capture was one from a couple weeks ago, no reason to put the scope on that one.

To many tools [smiley=rolleyes.gif] I am just trying to catch up to you [smiley=evilgrin.gif]

Now it's time for a  [smiley=beer2.gif]on my  [smiley=birthdays.gif] 41 I'm getting old and feeling it [smiley=eek.gif]

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 4:10pm
Here is a capture during a tap test.

Also we monitor power and ground sides of sensor to eliminate of a CKT problem.
tap_test.gif (46 KB | )

Title: Re: 2000 Pontiac Bonneville P0102
Post by Rafael on Sep 3rd, 2007 at 4:23pm
Thank you guys for taking the time to reply.

The point Im trying to make is; I know there are lots of techs trying to see which scope to get, the answer is right in front of you.

Driveability problems are no match for PICO scope.

The scope is easy to use and very powerful.

The tool is great and what makes it greater is - TOM and CARL and all of the techs helping each other out.

Thats what makes this site SECOND TO NONE !!!

Title: Re: 2000 Pontiac Bonneville P0102
Post by Tom Roberts on Sep 8th, 2007 at 10:34am
Rafael,

Thank you for the kind comments and acknowledgment.  Spread the word  ;)

The automotive service industry is a unique marketing challenge that requires a unique approach.  IMHO, a successful approach requires violating most generally accepted marketing principles.  We do things backwards.  Sales takes a back seat to training and support.  The marketing guys just don't get it.  Can't blame them really.  They just don't understand the industry.  You really have to have had a career on the inside to get it.  The value of what we do here at Autonerdz can only be appreciated by a professional technician.

Some may not be aware that we pioneered PicoScope in the automotive industry.  At that time, we were just prophets in the wilderness.  Now everyone is trying to get on the wagon  ;)  This creates some marketplace confusion and more than a little consumer regret resulting from price shopping and poor research.  

For the technicians out there looking at adding a PicoScope to their arsenal, I have only one thing to say:

Do your homework.

The Autonerdz Community Forums » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.